Weco Pioneer Pulse 321MKS, Instruction Manual, Page: 20 / 48

Cod . 006.0001.1600
11/07/2022 V.2.12
Pioneer 321 MKS
20
ENGLISH
3.5 LOCKING PROCEDURE
The procedure inhibits unit adjustments, allowing the user to modify only certain settings depending on
the selected lock status.
The procedure is used to prevent accidental alteration of the unit settings and welding settings by the
operator.
Enabling
If no locking status is selected (LOC = oFF) and if you wish to set up a limitation on use of the power
source, display the LOC function in the SETUP menu.
Open the Setup menu.
The acronym relative to the setting to be edited appears on the following displays: D1
The value relative to the selected setting appears on the following displays: D2
E1 Use the encoder to select the following setting: LoC
E2 Use the encoder to select the required lock status.
i
Depending on the selected Lock, certain functions will remain enabled.
E1 Use the encoder to select the following setting: ESC
S4 Press any button to save the setting and quit the menu.
- Functions not disabled by Locks
LOCK
STATUS
USER INTERFACE RC03 RC04 RC05 RC06
OFF
All adjustments enabled.
Key K1 disabled.
All adjustments
enabled.
All adjustments
enabled.
All adjustments
enabled.
All adjustments
enabled.
1
Selection of torch trigger procedure
(button S5)
Display of main welding parameters
(button S4)
Arc correction (encoder E2)
Wire insertion (button S1)
Gas test (button S2)
Arc correction
(Potentiometer
Pot2)
Arc correction
(UP/DOWN
lever 2)
2
Selection of torch trigger procedure
(button S5)
Display of main welding parameters
(button S4)
Arc correction (encoder E2)
Synergy (encoder E1)
Wire insertion (button S1)
Gas test (button S2)
All adjustments
enabled.
All adjustments
enabled.
All adjustments
enabled.
All adjustments
enabled.
3
Selection of torch trigger procedure
(button S5)
Display of main welding parameters
(button S4)
JOB selection (encoder E2)
Wire insertion (button S1)
Gas test (button S2)
Scroll JOBS
(UP/DOWN
lever 1)
Scroll JOBS
(UP/DOWN
lever 1)