Weco Cruiser 402 T, Instruction Manual

Page: 10 / 50

Cod.006.0001.1680
24/04/2014 v2.0
ENGLISH
Cruiser 402 T - Cruiser 502 T
Power Pulse 402 T - Power Pulse 502 T
10/50
3 COMMISSIONING
3.1 USER INTERFACE
CODE SYMBOL DESCRIPTION
L1 This LED illuminates to confirm the presence of power on the output sockets.
L2
This LED illuminates to show an anomaly in the operating conditions.
See § 3.5 ALARMS MANAGEMENT page 16.
L3 Illuminates to show that a previously saved JOB has been loaded.
L4 Illumination shows that the following function has been activated:
HIGH FREQUENCY ARC STRIKE (HF)
L5
Illumination shows that the following function has been activated: VRD (reduced output voltage).
The no-load voltage between the welding sockets is switched from U
0
to U
r
(see technical data).
L6 Illuminates to show a value in the following unit of measurement:
AMPERES
L7
Illuminates to show the last voltage and current values measured during welding.
The value appears on the following displays: D1-D2
The LED switches off when a new welding procedure is started, or when any of the welding settings is modified.
L8 Illuminates to show a value in the following unit of measurement:
VOLTS
L9
Illuminates to show a value in the following unit of measurement:
MILLIMETRES
L10 Illuminates to show a value in the following unit of measurement:
AMPERES
L11 Illuminates to show a value in the following unit of measurement:
SECONDS
L12 Illuminates to show a value in the following unit of measurement:
HERTZ
L13 Illuminates to show a value in the following unit of measurement:
KILOHERTZ
L14 Illuminates to show a value in the following unit of measurement:
PERCENTAGE
L15 When this LED illuminates the following parameter can be set:
Q-START
L16
When this LED illuminates the following parameter can be set:
DYNAMIC ARC
L17
When this LED illuminates the following parameter can be set: MULTI TACK
L18 When this LED illuminates the following parameter can be set:
STARTING CURRENT
L19 When this LED illuminates the following parameter can be set:
SLOPE UP
L20 When this LED illuminates the following parameter can be set:
WELDING CURRENT