Page
2
of
16
Description
The cutter is intended for use on Coflexip type riser and will cut hose up to 270mm diameter. It
may be used on alternative materials, such as electrical power or communication cables, up to a
maximum of 200mm diameter. Where small diameters are to be cut, effort should be made to
place the material centrally along the anvil to minimise any offset loading. The cutter is not
designed to cut large diameter wire rope.
IMPORTANT
If it is required to extend the recommended use of the cutter, for instance to cut solid steel bar
or wire rope, please refer to the manufacturer with full details of material size and tensile
strength. Cutting unsuitable materials could result in damage to the tool.
1
.
SAFETY
Before operation, read and understand this operations manual.
Whilst the tool is intended for remote or local operation sub-sea, there is no reason why it
should not be used above surface.
Ensure that the tool, hoses and pump are in good condition and properly connected.
Ensure that suitable pressure regulation equipment is used and that the unit is not subjected to
pressures higher than those stated in section 3
In all cases, where an operator is present, the safety aspects must be reviewed before the
cutting operation is commenced.
No attempt should be made to cut any material that is under tension.
Ensure that the operator is shielded from the cutting blade during the cutting operation.
When cutting near the very end of hose fragments can be expelled from the tool, please ensure
that the operator is shielded from these.
If in doubt please contact the manufacturer (Allspeeds Ltd) or an authorized distributor for
assistance.
If at any time it is necessary to carry out proof tests on the tool, e.g. after service on the
hydraulic cylinders, it must be returned to the supplier for testing where the following
procedures apply.
The maximum proof test pressure should not exceed 125% of the maximum working pressure
and this should only be done by Allspeeds using our specially adapted test rig.
The tool should be guarded during the proof test operation, and be carried out in
a safe working environment.
The proof pressure should be applied gradually, until the maximum pressure is reached.
