MultiPort/LT User Reference
Page 49
Inside MultiPort/LT and Monitor Commands
Opt-Conf> ns116
Option: NS116; Don't use IEN116 style IP nameserver lookup;
alter? y
Will use IEN116 style IP nameserver lookup;
Opt-Conf> rarp
Option: RARP; Use the RARP protocol to discover IP address;
alter? y
Won't use RARP (if needed) to locate IP address
Opt-Conf> bootp
Option: BOOTP; Use the BOOTP protocol to discover IP address;
alter? y
Won't use BOOTP (if needed) to locate IP address
Opt-Conf> rameeprom
Option: RAMEE; Ignore master copy of eeprom if valid on power up;
alter? y
Will use, if valid master eeprom copy;
Opt-Conf> ramsave
Option: RAMSave; Trash ram contents in power on selftest;
alter? y
Will attempt to save ram contents at start up/reset;
Opt-Conf> trustworthy
Option: TRUSTworthy;Run power up hardware selftest;
alter? y
Will assume hardware is O.K. at startup;
Opt-Conf> errdiags
Option: ERRdiags; Enter diagnostic mode if startup self test fails;
alter? y
Won't enter diagnostics on self test failure;
Opt-Conf> diagnosticmode
Option: DIAGNosticmode; Startup normally;
alter? y
Diagnostics monitor enabled;
Opt-Conf> quit
Conf>
