8
2
5
6
GAS INSTRUCTIONS
1
3
4
7
The grills illustrated in this
Owner’s Guide may vary slightly
from the model purchased.
INSTALLING THE CYLINDER
Purchase A Full Cylinder Of Gas From Your Gas Dealer
The cylinder must always be installed, transported and stored in an upright position.
Never allow the cylinder to drop or be handled carelessly. Never store the cylinder
where temperatures can exceed 51° C (too hot to hold by hand). For example, do not
leave the cylinder in your car on hot days. (Refer to: “SAFE HANDLING TIPS FOR LP GAS
CYLINDERS”).
◆
CYLINDER INSTALLATION LOCATION OPTIONS
You may mount the cylinder to the right side panel using the cylinder hanger or place the
cylinder on the ground. The cylinder must be placed outside the base cabinet, on the right
side of the grill. Do not attempt to install the cylinder inside the base cabinet.
Cylinder Hanger Installation
You will need: the cylinder hanger bracket
(1) and cylinder hanger (2).
A) Position the cylinder hanger bracket on the right outside panel of the grill. Fasten with
screws, washers and nuts
(3).
B) Install the cylinder glides
(4) into the two holes below the cylinder hanger bracket.
Fasten with screws, washers and nuts.
C) Turn the cylinder so the valve opening faces the front of the grill.
D) Hold the cylinder hanger and tilt the cylinder so the two bent supports of the cylinder
hanger are located underneath the cylinder base flange. Adjust the belt so that it is
tight to the cylinder
(5).
E) Lift and place the cylinder hanger on the cylinder hanger bracket as shown
(6).
Ground Placement
A) Place the cylinder on the ground, outside the base cabinet, on the right side of the grill
(7).
B) Turn the LP cylinder so the opening of the valve is facing the front of the WEBER gas
grill.
◆