Weber Geset 117, Original User Manual

Page: 44 / 59

Chapter 8 Operation
40002674 BTA Geset 117
Version: 15.01.14
page 44 of 59
GB
Stop labeling operation
Requirements
¥
Labeling system is in labeling operation (s.a.)
Instruction
Please stop labeling operation as follows.
Step Procedure
1 If possible, the labeling system should be run empty.
2
Push the [OFF]-button at the switch cabinet to stop automatic labeling
operation.
3 Switch off the labeler (cp. page 42).
4
Remove all products.
5 Observe the notes „Putting the system out of service“ (s. page 44).
Putting the system out of service
When turning off the system for several hours, the label web
must be removed from the labeler to avoid failures at re-start.
The label material running around the deflection rollers is curved which can cause
problems with the operation mode. This characteristic of the labels as well as the retained
curvature depend on the material which can vary significantly between the different print
media. The ambient conditions such as high temperatures and humidity enhance this
effect.
Remove critical label material before long breaks and after end of work from
labeler!
Instruction
Please put the label system out of service as follows.
Step Procedure
1 Stop labeling operation (s. page 44)
2
Turn off labeling machine (s. page 42)
3 Disconnect the power supply.
4 Protect the labeling station if applicable from dust with a cotton or linen cloth.
5 If the labeling system should be stored and/or transported, please observe
the notes referring…

Transport (page 25)

Storage conditions (page 28)
6 Transport the labeling station like described in chapter „Transportion and
unpackaging“ to its storage location.
*
*²Only if system has the appropriate features.