Weber GENESIS 56733, Assembly Manual

Page: 31 / 36

www.wEBER.COm
® 31
1
2
ChECK FOR gAS lEAKS
For complete gas instructions see Operating guide.
The grill illustrated may have slight
differences than the model purchased.
m DAngER
Do not use an open flame to check for gas leaks. Be sure
there are no sparks or open flames in the area while you
check for leaks. Sparks or open flames will result in a fire or
explosion, which can cause serious bodily injury or death
and damage to property.
Note: All factory-made connections have been thoroughly checked for gas leaks. As a
safety precaution however, you should recheck all fittings for leaks before using your
Weber® gas barbecue. Shipping and handling may loosen or damage a gas fitting.
m WARning: The gas connections of your gas grill have been
factory tested. We do however recommend that you leak
check all gas connections before operating your gas grill.
m WARning: Perform these leak checks even if your barbecue
was dealer or store assembled.
If your grill has a side burner make sure the side burner is turned off.
Turn on gas supply at source.
m WARning: Do not ignite burners when leak checking.
You will need: A soap and water solution and a rag or brush to apply it.
A) Mix soap and water.
B) Turn on gas supply.
C) Check for leaks by wetting the fitting with the soap and water solution and watching
for bubbles. If bubbles form, or if a bubble grows, there is a leak.
if there is a leak, turn off the gas and tighten the fitting. Turn the gas back on and
recheck with the soap and water solution. if leak does not stop do not use the
barbecue. Contact the customer service representative in your area using the
contact information on our web site. log onto www.weber.com
®
.
D) When leak checking is complete, turn gas supply off at the source and rinse
connections with water.
Note: Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.
m WARning: You should check for gas leaks every time you
disconnect and reconnect a gas fitting.
Check
A) Side burner quick-disconnect connection (1).
B) Side burner extension quick-disconnect connection (2).
m WARning: if there is a leak at connections (1 or 2), turn
OFF the gas. DO nOT OPERATE ThE gRill. Contact the
Customer Service Representative in your area using the
contact information on our web site.
log onto www.weber.com
®
.
When leak checks are complete, turn gas supply OFF at the source and rinse
connections with water.
◆
LEAK CHECK