Procedure:
The cutter is positioned with the type plate pointing
upward and is fixed in place. A clamping device, as
shown in the illustrations, is not obligatory.
When the blade insert is being changed, the battery
must be removed from the cutter and not under load.
This means that the shear is not completely open
or closed.
The blade insert for the cutter blade with the smooth
surface can now be replaced.
The roll pins are knocked out and downward
from the punch (see figure 1).
Fig. 1
After the roll pins have been knocked out of
their position, the blade insert can be pulled out.
The use of a forked screwdriver is recommended.
If the blade insert cannot be loosened immediately,
it can be gently levered out using a punch in the holes.
(see figure 2).
Fig. 2
Next, the cutter is rotated and the blade insert is
placed in the cutter blade with no insert.
When inserting, make sure that the blade insert does
not twist. If the blade inserts cannot be inserted by
hand, use the soft-head hammer (see figure 3).
Fig. 3
