HD MotionCam
Installation Manual
EN.PM.UM24 20160211
-18-
Page 18 of 29
Outdoor Installation
For the following steps, the items listed below will be needed:
Mounting Arm
Install Sealant
HD MotionCam in Housing
Camera Support and Clamp
Connector for Camera to Mounting Arm
7/16” Nut Driver
Cable Ties
5 mm Allen Wrench
1.
Make sure the mounting arm will be mounted high enough so that the camera
pan/tilt/zoom features can be utilized. On the outside wall where the cables
have been pulled through and the camera is to be mounted, attach the
mounting arm to the wall and secure tightly (hardware not included). The
mounting arm should go over the hole created for the cables. The Power and
Ethernet Cables should be fed through the Mounting Arm for the camera
connection to be made. Once the Mounting Arm is secured to the wall, use
the Install Sealant around the outside of where the mounting arm meets the
wall to keep moisture from leaking behind the mounting arm and down the
cables.
2.
Remove the protective tape from the mounting arm.
