Version 2 - 12/22/2011
Page 12 of 24
The Wireless Outdoor Sensor sends temperature data to your Wireless Display, accurate to
within a tenth of one degree.
The Outdoor Temperature Sensor uses 2 x “AA”,
Alkaline
batteries. To install and replace the batteries, please follow
the steps below:
1. Remove the battery compartment cover on the back
of the sensor.
2. Insert the batteries, observing the correct polarity
(see marking).
3. Replace the battery compartment cover on the unit.
Press the “DISPLAY” Key repeatedly on your Wireless Display until the outdoor temperature is
displayed in the center scroll line (right side next to the word
Out
).
Time Setting on Wireless Display
The Time Zone you select on
www.weatherdirect.com
for your
Wireless Display is intended to set
the time for your physical location
so the clock on your Wireless
Display is accurate. This time is
independent of your selected
forecast locations. The Wireless
Display will ONLY display the time
from the “Time Zone for Wireless
Display Clock” set on the web site,
NOT the time at the forecast
locations. There is only one Time
Zone available per Wireless
Display.
The Daylight Saving Time (DST)
checkbox on your Wireless Display
settings at
www.weatherdirect.com
is selected by default because most
locations observe DST. If you are
in a location that does not observe DST, please make sure to uncheck this box.
