MagiCube User Manual
WeAre3D.ca
Copyright 2015 We Are 3D Inc.
Page 18
7.
Wait for printer to home and heat up.
8.
Print will start after heating up is done.
6.4.2.
From USB
1.
Ensure printer enclosure is free of foreign objects.
2.
Make sure print bed is properly seated, and that the blue tape is not worn out or smooth.
3.
Make sure filament is loaded into the hot-end and routed through the guide tube at the back of the
enclosure.
4.
Plug the printer in using the USB cable provided.
5.
Open AnyPrint from the Start Menu on your computer.
6.
Choose ‘Import File’
7.
Select preferred options. For more information refer to the AnyPrint section of this manual.
8.
Click ‘Print’.
9.
Wait for printer to home and heat up.
10.
Print will start after heating up is done.
6.5.
During the print
•
Keep hands and objects out of the printer.
•
Make sure Print doesn’t detach from bed in the first layers.
•
Make sure that filament does not run out.
•
If the filament was not routed properly, it may get stuck and cause the print head to get misaligned. Be
sure to watch for any disruptions while printing.
6.6.
Pausing or cancelling
To interrupt a print, press the knob for 2 seconds, you can then select ‘Pause’ or ‘Cancel’. If you are printing
from the computer you can also pause the print using the print dialog box.
Pausing will allow you to resume afterwards. If the printer loses power or the print head or bed move while the
print is paused, the printer will lose its place on the print. This will cause an offset part.
Cancelling will stop the print and move the head out of the way to allow you to remove the print.
6.7.
After the print
1.
Wait for the print head to move out of the way and cool down. (5 minutes)
2.
Lift the bed out of the printer with the part attached.
3.
Remove part from bed by using plastic scraper, a razor blade, or pry it off with your hands.
4.
Clean off any excess filament on the bed.
5.
Inspect the enclosure for plastic debris and remove if you see any.
6.
Re-tape the bed if tape has worn out.
7.
Place bed back into the printer for next print and ensure it is properly seated.
Summary of Contents for MagiCube
Page 1: ...User Manual Rev A ...
