ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
· Ensure a barrel blocking device is fitted
to the ANGEL.
· Ensure the hopper is removed from
the ANGEL.
· Ensure that there are no paintballs
in the ANGEL.
· Always remove the first stage regulator and
release all residual gas pressure from the
Angel before disassembly.
· The Angel can hold a small residual gas
charge, typically two shots, with the first stage
regulator removed. Always discharge the Angel
in a safe direction to relieve this residual gas
pressure.
· SHOULD YOU BE UNSURE AT ANY STAGE YOU
MUST SEEK EXPERT ADVICE.
Angel eyes removal
•
Carefully extract the eyes from the body.
See ’Angel eyes servicing’ (page 22) opposite.
Then:
•
Remove the right hand grip cheek cover
0
by
removing the 3 retaining screws
using a metric
2mm Allen key.
•
Unplug the solenoid plug
from the PCB.
•
Remove the Angel eyes ribbon cable connectors
from the ZIFF socket on the PCB.
•
Remove the Grip Frame
by removing the 2
retaining screws
using a 3mm Allen key.
•
Carefully remove the Angel Eyes
.
Important Notes for re assembly:
Ensure no wires become trapped between the body
and the grip frame during re assembly.
When reassembling the Angel Eyes, place the eyes
back into their location holes then feed the ribbons
into the channels on the front and underside of the
body. Hold the eyes and Rubber Finger Detents in
place with one hand and slide the cover on with
the other.
NOTE: WHEN RECONNECTING THE EYE RIBBONS TO THE PCB
THE SHORTER RIBBON CONNECTS TO TOP ZIFF SOCKET.
0
