![background image](http://html1.mh-extra.com/html/wazer/wazer-main-unit/wazer-main-unit_user-manual_878754027.webp)
Finalize water connections
•
Install Water Filter
•
Install the On/Off Valve
•
Perform a Leak Test
1.
Install the Inlet Water Filter and On/Off Valve
Once you have completed the three hose connections, install of the Water Filter and On/Off
Valve needs to be done. They should be placed in a convenient location within the path of
the Water Inlet Hose. We suggest placing it as close as possible to the water supply in case
of damage to the hose farther downstream. Make sure the location of these components
are easily accessible so that users can easily turn it on and off as well as monitor the inlet
pressure and cleanliness of the filter on a regular basis.
•
Ensure that the water supply to the Water Inlet Hose is turned off.
•
Open your “WAZER Inlet Water Filter” box.
•
Attach the two push-to-connect fittings to the inlet and outlet of the water filter by
tightening them onto the threads
•
Using the Sheetrock anchor and/or fastener, mount the bracket to your selected surface. A
single fastener in the middle of the bracket is all that is needed to mount it.
•
Cut the Water Inlet Hose with a sharp box cutter so that it can be routed to the outlet of
the Water Filter, which you can identify with the arrow indicator on the water filter. We
recommend leaving some slack in the line to allow for the water filter to be dismounted
from its bracket if needed in the future.
•
Cut a small section of the leftover Water Inlet Tube (12”-24”) with a sharp box cutter and
insert it into the inlet side of the Water Filter. Insert the other end of the cut hose into the
On/Off valve.
•
The remainder of the Water Inlet Hose can be cut to length to be routed between your sink
adapter or Garden Hose Adapter installed at the beginning of this hose setup procedure.
We recommend leaving enough slack to create a small loop in the line near the connection
point. This allows extra slack to reposition in the future and relieves the joints to prevent
leaking.
•
Attach the silicone “flushing” hose with the hose clamp to the bottom of the Water
Filter. You can find instructions on this in Section 7 Maintenance>Misc Maintenance
Procedures>Cleaning the Water Filter Inlet
Make sure to fully seat the hose into the On/Off Valve and Water Filter. You will
feel a level of resistance (the seal) that you need to push past until the hose is fully seated in the
connection. A total of about 1” of hose should be inserted into each side of the On/Off Valve.
It is important to shut the Water Inlet Hose off whenever WAZER is left idle;
not doing this could
lead to a massive water leak or damage to the unit. The valve also acts as a quick access safety
mechanism to help limit damage in the event that an accident occurs.
2.
Perform a Leak Test
•
Inspect all water connections. Make sure every connection is well-seated and matches the
descriptions in this User Manual.
•
Turn on the water supply to the Water Inlet Hose, and turn on the On/Off Valve
•
Inspect every point in the connection for leaks.
•
Leave the water supply on for a few minutes and recheck the connections for any slow drips.
•
Shut the On/Off Valve before continuing on to the next section.
The On/Off Valve is OPEN when the handle is parallel with the hoses.
The On/Off Valve is CLOSED when the handle is perpendicular to the hoses.
Set
tin
g Up W
AZER |
SE
C
TION 4
46
47