Hose 3: Install the High-Pressure Hose
The High-Pressure Hose transfers high-pressure water between WAZER Main Unit and the Pump Box.
This hose is 5 ft. long. Ensure that it reaches between the two units without inducing stress at the
joints. Do not route this hose in a way that will cause abrasion, pinching, or puncture. In particular,
check for pinching between your desktop and the wall.
This hose has Quick Connect fittings attached at either end. To make the connection, pull back the
collar and then push the female end firmly into the High-Pressure Hose Connection, making sure
to seat the fittings completely.
1. Connect one end of the High-Pressure Hose to the High Pressure Hose Connection located
on the back of the Pump Box.
Ensure the fitting is fully seated and the collar has snapped
forward. Pull on the hose to be certain of the connection.
2.
Connect the second end to the High-Pressure Connection located on the back corner of
WAZER.
Ensure that fitting is full seated and the collar has snapped forward. Pull on the
hose be certain of the connection.
Make sure the Pump Box is in a location that does not cause added stress to the High-
Pressure and Water Inlet Hoses.
Make sure the High-Pressure Hose does not bend too sharply coming out of the back of the Pump
Box. If there is a sharp bend, the High-Pressure Connections will experience uneven stresses. This
stress will cause the internal O-Ring to fail and release high-pressure water.
If you notice water leaking from your High-Pressure Connections, please refer to
our website.
If there is a leak or things get wet that likely shouldn’t have, please turn everything off, wipe it down,
and LET IT DRY overnight before seeing if anything was damaged and is still working.
Visually check High-Pressure Hose before installation. If the High-Pressure Hose outer layer has been
damaged down to the outer wire layer, the High-Pressure Hose shall be withdrawn from use. Contact
WAZER for replacement
Set
tin
g Up W
AZER |
SE
C
TION 4
44
45