830872-0001 REV 12/07/2022
©Copyright 2022 Wayne Dalton, a division of Overhead Door Corporation
18
Operator Install (continued)
13. BENCH MOUNT (CONTINUED)
ATTACH OPERATOR TO DOOR:
• Mount operator assembly to weld plate and install mounting hardware, do not tighten. See Figure 24
• Attach 12 tooth sprocket and key to operator output shaft, do not tighten.
• Attach door sprocket and key to
door shaft, do not tighten.
• Install chain onto sprockets.
• Adjust operator to remove slack from
chain. Be certain operator output
shaft is parallel with door shaft.
• Tighten operator mounting bracket
nuts.
• Apply locking compound to all
sprocket setscrews and tighten
4.5
Attach Operator to Door:
4. Mount operator assembly to weld plate and install mounting hardware, do not tighten. Fig. 12
5. Attach 12 tooth sprocket and key to operator output shaft, do not tighten.
6. Attach door sprocket and key to door shaft, do not tighten.
7. Install chain onto sprockets.
8. Adjust operator to remove slack from chain. Be certain operator output shaft is parallel with door shaft.
9. Tighten operator mounting bracket nuts.
10. Apply locking compound to all sprocket setscrews and tighten.
Bench Mount
(continued)
Fig. 12
Section 4: Installation
Figure 24
Operator Install (continued)
