830872-0001 REV 12/07/2022
©Copyright 2022 Wayne Dalton, a division of Overhead Door Corporation
15
11. FRONT AND TOP OF HOOD MOUNT (CONTINUED)
ATTACH OPERATOR TO DOOR.
• Mount operator assembly to weld plate and install mounting hardware, do not
tighten. See Figure 18
• Attach 12 tooth sprocket and key to operator output shaft, do not tighten.
• Attach door sprocket and key to door shaft, do not tighten.
• Install chain onto sprockets.
• Move and align sprockets and chain as close to the operator as possible. See
Figure 19
• Adjust operator to remove slack from chain. Be certain operator output shaft is
parallel with door shaft.
• Tighten operator mounting bracket nuts.
• Apply locking compound to all sprocket set screws and tighten.
Operator Install (continued)
4.2
Attach Operator to Door.
6. Mount operator assembly to weld plate and install mounting hardware, do not tighten. Fig. 5
7. Attach 12 tooth sprocket and key to operator output shaft, do not tighten.
8. Attach door sprocket and key to door shaft, do not tighten.
9. Install chain onto sprockets.
10. Move and align sprockets and chain as close to the operator as possible. Fig. 6
11. Adjust operator to remove slack from chain. Be certain operator output shaft is parallel with door shaft.
12. Tighten operator mounting bracket nuts.
13. Apply locking compound to all sprocket set screws and tighten.
Fig. 5
Front and Top of Hood Mount
(continued)
Fig. 66
TOP VIEW
FOH mount
shown
Front of Hood
Top of Hood
Section 4: Installation
4.2
Attach Operator to Door.
6. Mount operator assembly to weld plate and install mounting hardware, do not tighten. Fig. 5
7. Attach 12 tooth sprocket and key to operator output shaft, do not tighten.
8. Attach door sprocket and key to door shaft, do not tighten.
9. Install chain onto sprockets.
10. Move and align sprockets and chain as close to the operator as possible. Fig. 6
11. Adjust operator to remove slack from chain. Be certain operator output shaft is parallel with door shaft.
12. Tighten operator mounting bracket nuts.
13. Apply locking compound to all sprocket set screws and tighten.
Fig. 5
Front and Top of Hood Mount
(continued)
Fig. 66
TOP VIEW
FOH mount
shown
Front of Hood
Top of Hood
Section 4: Installation
Figure 18
Figure 19
4.2
Attach Operator to Door.
6. Mount operator assembly to weld plate and install mounting hardware, do not tighten. Fig. 5
7. Attach 12 tooth sprocket and key to operator output shaft, do not tighten.
8. Attach door sprocket and key to door shaft, do not tighten.
9. Install chain onto sprockets.
10. Move and align sprockets and chain as close to the operator as possible. Fig. 6
11. Adjust operator to remove slack from chain. Be certain operator output shaft is parallel with door shaft.
12. Tighten operator mounting bracket nuts.
13. Apply locking compound to all sprocket set screws and tighten.
Fig. 5
Front and Top of Hood Mount
(continued)
Fig. 66
TOP VIEW
FOH mount
shown
Front of Hood
Top of Hood
Section 4: Installation
