WBSn-2400 User Guide
Page - 6 -
Installation
This document is intended to help you set up and configure your WBSn-2400 base station. Unless
specified otherwise, the use of the product name WBSn-2400 refers to all WBSn-2400 base stations.
WBSn-2400 Pre-Installation Checklist
The following checklist covers all the procedures and equipment that you need to acquire and assemble,
prior to beginning the installation and configuration procedures. Ensure that you check this list carefully,
before beginning any of the procedures described later in this Guide.
Check contents of package
WBSn-2400-O
WBSn-2400-O base station unit (Omni)
PoE injector unit
3 antennas
Post-clamp
Two steel bands
2 screws, each with attached spring and flat washers
Iron security cable
Waterproof sealing tape for IP68 (band to sealing rubber)
Plastic cap and cap cover
WBSn-2400-S
WBSn-2400-S unit (Sector)
PoE injector unit
Post-clamp
Two steel bands
2 screws, each with attached spring and flat washers
Iron security cable
Plastic cap and cap cover
Warning
The WBSn-2400 should only be installed using the antennas provided as part of the
original package.
Ensure that the USB port on the base station unit is properly sealed.
Additional equipment and tools required for installation
•
Ethernet cable (outdoor CAT5e 4-pair data cable, with RJ45 connectors)
Note: Maximum cable length -- 100 meters
•
Ground cable
•
Portable PC
•
Lightning protection
•
1”-6” diameter pole (on which to mount the unit)
