12 of 14
WX-501-0537 • 01.22
Setting
Description
Command
Allows you to set the command sent from the device during the autobaud process. This option is
currently not available.
Response
Shows the response the device is expecting from the above command. This option is currently not
available.
SmartSensor ID
Shows the ID number of the sensor with which the Click device is currently communicating. This
option is currently not available.
Server/Client
Allows you to set whether the device is a server or client in a point to multipoint setup (this option is
not related to device autobauding). This option is currently not available.
When you open the
512
tab, you will see ten tabs. The first is labeled
Overall
. This tab allows you to configure
values for the speed and length thresholds (see the figure and table below).
Note.
Values in Click Supervisor will be displayed according to the units (English or metric) selected in SSMHD.
Setting
Description
Trigger Sync
Sets the method of trigger synchronization. The options are: Automatic (English),
Automatic (Metric) or None.
Setback distance
Distance between the sensor and a downstream location on the roadway.
Depending upon the trigger method, the downstream location may be the actual
location of the roadway sign, or somewhere in between. If units are English, this
distance is in feet; if Metric, then the distance is in decimeters.
ETA (ms)
If you are not using the ETA trigger method, leave this value at 0. Otherwise, this is
the ETA to the downstream location.
