Call 800.879.8585 for Technical Support
COVERAGE PATTERNS
Coverage testing has been
performed according to the
NEMA WD 7 guideline. For best
performance, use in spaces not
larger than 15’ x 12’.
PIR Sensor
The sensor has a two-tiered,
multi-cell viewing Fresnel lens with
180 degree field of view. The red
LED on the sensor flashes when the
PIR detects motion.
Masking the lens
Opaque adhesive tape is supplied
so that sections of the PIR sensor’s
view can be masked. This allows
you to eliminate coverage in
unwanted areas. Since masking
removes bands of coverage,
remember to take this into
account when troubleshooting
coverage problems.
PIR
Coverage
7.5’
(2.2m)
15’
(4.5m)
20’
(6.1m)
35’
(10.6m)
Major motion
Minor motion
Alerts
The PW-100-24 can provide audible and/or visible alerts as a warning before
the load turns OFF.
Unit will beep at one minute, at 30 seconds and at 10
seconds before turning
OFF
load. When Walk-Through
is active, the unit beeps three times at 10 seconds
before the load goes
OFF
.
*If Visible Alert is also
ON
, the one-minute time-out
warning beep is replaced by the visible alert.
Audible Alerts
(DIP #7
ON
)
No audible warnings provided.
When only one minute is left in the time delay, the
load connected to the relay turns
OFF
for one second.
This provides a one minute warning before the load(s)
are turned
OFF
by the sensor.
Visible Alert
(DIP #6
ON
)
No Visible Alerts
(DIP #6
OFF
)
No visible warnings provided.
No Audible Alerts
(DIP #7 OFF)
4’
(1.2m)
20’
(6.1m)
35’
(10.6m)
0
Top View
Side View
