background image

Ordering Code

Description

Case Qty/Wt.

WP500342

ZRO-4 (2 pack)

2 lbs

• (1) 10" 5 micron sediment filter
• (1) 10" carbon block filter

WP500340

ZRO-4 (4 pack)

4 lbs

• (1) 10" 5 micron sediment filter
• (1) 10" carbon block filter
• (1) 10" Inline final filter
• (1) 25 GPD thin film membrane

14

Limited Warranty 

What your Warranty Covers: 

If any part of your WATTS PURE WATER Reverse Osmosis System is defective in workmanship (excluding replaceable filters and
membranes), return unit after obtaining a return authorization (see below), less tank, within 3 years of original retail purchase.
WATTS PURE WATER will repair or, at WATTS PURE WATER'S option, replace the system at no charge. 

How to obtain Warranty Service: 

For warranty service, call 1-800-752-5582 for a return authorization number. Then, ship your Reverse Osmosis unit (less tank) to
our factory, freight and insurance prepaid, with proof of date of original purchase. Please include a note stating the problem.
WATTS PURE WATER will repair it, or replace it, and ship it back to you prepaid. 

What this warranty does not cover: 

This warranty does not cover defects resulting from improper installation, (contrary to WATTS PURE WATER'S printed instruc-
tions), from abuse, misuse, misapplication, improper maintenance, neglect, alteration, accidents, casualties, fire, flood, freezing,
environmental factors, or other such acts of God. 

This warranty will be void if defects occur due to failure to observe the following conditions: 

1. The Reverse Osmosis System must be hooked up to a potable municipal or well cold water supply. 

2. The hardness of the water should not exceed 7 grains per gallon, or 120 ppm. 

3. Maximum incoming iron must be less than 0.2 ppm. 

4. The pH of the water must not be lower than 3 or higher than 11. 

5. The incoming water pressure must be between 40 and 100 pounds per square inch. 

6. Incoming water to the RO cannot exceed 105 degrees F (40 degrees C.) 

7. Incoming TDS/Total Dissolved Solids not to exceed 1800 ppm. 

8. Do not use with water that is micro-biologically unsafe or of unknown quality without adequate disinfection before or after 

the system. 

This warranty does not cover any equipment that is relocated from the site of its original installation.

This warranty does not cover any equipment that is installed or used outside the United States of America.

LIMITATIONS AND EXCLUSIONS: 

WATTS PURE WATER WILL NOT BE RESPONSIBLE FOR ANY IMPLIED WARRANTIES, INCLUDING THOSE OF 
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. WATTS PURE WATER WILL NOT BE RESPONSIBLE 
FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING TRAVEL EXPENSE, TELEPHONE CHARGES, LOSS 
OF REVENUE, LOSS OF TIME, INCONVENIENCE, LOSS OF USE OF THE EQUIPMENT, AND DAMAGE CAUSED BY THIS
EQUIPMENT AND ITS FAILURE TO FUNCTION PROPERLY. THIS WARRANTY SETS FORTH ALL OF WATTS PURE WATER'S
RESPONSIBILITIES REGARDING THIS EQUIPMENT.

OTHER CONDITIONS:

If WATTS PURE WATER chooses to replace the equipment, WATTS PURE WATER may replace it with reconditioned equipment.
Parts used in repairing or replacing the equipment will be warranteed for 90 days from the date the equipment is returned to you
or for the remainder of the original warranty period, whichever is longer. This warranty is not assignable or transferable.

YOUR RIGHTS UNDER STATE LAW:

Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or 
limitation of incidental or consequential damages, so the above limitations or exclusions may not apply. This warranty gives 
you specific legal rights, and you may have other legal rights which vary from state to state.

Replacement Filter Kits

Summary of Contents for ZRO-4

















Reviews: