Step 1
Determine desired location to drill a hole for the faucet on your sink.
Step 2
Using a variable speed drill on the slowest speed, drill a
7
/
16
" hole for the faucet. Use water to keep the drill bit
cool while drilling. (If the drill bit gets hot it may cause the porcelain to crack or chip).
Step 3
Place the escutcheon chrome plate and the black rubber washer on the faucet shank. (Parts found in faucet
parts bag).
Step 5
From the underside of the sink slide on the locating washer, lock washer and brass nut onto the shank. Check orien-
tation of faucet then tighten brass nut securely.
Installation of Faucet
Caution: Porcelain sink surface material is extremely hard and may crack or chip. Use extreme caution when drilling.
Watts accepts no responsibility for damage resulting from the installation of the faucet.
Black Locating Washer
(used where a
1
/
2
" hole is
available, reverse when
mounting on stainless steel
or when using drilled hole)
Escutcheon Plate
Black Rubber Washer
Brass Insert (sleeve)
Plastic Sleeve
1
/
4
" Compression Nut
1
/
4
" Tube
Shank
Nut
Lock Washer
Counter Top/Sink
4
