Page 8
Drain Saddle Installation -
Fits standard 1 ¼” – 1 ½” drain pipes
Caution: Do not install this drain saddle near a garbage disposal.
It must be above the disposal or above the crossbar on a
second sink drain. Installing the drain saddle near a garbage
disposal may cause it to clog. Please also make sure the
drain saddle is mounted at least 1 1/2” above the nut of the
p-trap or cross bar from the garbage disposal
Notice: Follow all local plumbing codes for your installation.
Step 7. Determine if a 1/4” tube connection or 3/8” tube connection drain
saddle should be installed. For air-gap RO faucets (3 tubes) use
the larger 3/8” tube connection drain saddle. For non air-gap RO
faucets (1 tube) use 1/4” tube connection drain saddle.
Step 8. Mark the location for the opening on the drain pipe then drill a:
3/8” opening in the drain for 3/8” drain saddles
OR
1/4” opening in the drain for 1/4” drain saddles
Step 9. Peel and stick the foam gasket onto the drain saddle
Step 10. Attach the drain saddle to the pipe using the bolts.
Caution: Do not over-tighten bolts. This may crack the drain saddle
Step 11. Check that the opening in the drain saddle is lined up with the
opening in the drain pipe by feeding a small screw driver through
the opening.
P-Trap
Elbow
1.5”
Step 12
( A ) 1/4” Tube Fitting Drain Saddle
Drain Saddle Tube Connection
Push the 1/4” red drain tube open end into the 1/4” quick
connect fitting on the drain saddle making sure it is pushed all
the way to the tube stop. Continue to step 14 on the next page.
Choose your configuration below (
A - 1/4” or B - 3/8”
):
Step 13A-1 In the parts bag, locate the 1/4” red tube. Connect the tube
to the open quick connect fitting on the top of the RO Module
labeled “Drain” making sure the tube is pushed in all the way
to the tube stop.
Step 13A-2
