background image

IOM-WQ-SmartStream-A   1909 

EDP#2915189 

© 2019 Watts 

USA:

  Tel: (800) 659-8400 • Fax: (800) 659-8402 • Watts.com

Canada:  

Tel: (905) 332-4090 • Fax: (905) 332-7068 • Watts.ca

Latin America:  

Tel: (52) 81-1001-8600 • Watts.com

Limited Warranty

Watts Regulator Co. (the “Company”) warrants its SmartStream

 ultraviolet disinfection product to be free from defects in material and 

workmanship under normal usage for the following periods beginning on the date of original shipment:
• Stainless steel reactor chamber – 10 years 
• Flow Switch – 3 years
• Electronics and ballast – 5 years prorated 
• UV lamp, quartz sleeve, UV sensor and all other components - 1 year
In the event of such defects within the applicable warranty period, the Company will, at its option, repair or replace the product with-

out charge.  Defective components are subject to inspection by the Company before any warranty remedy is provided.  The Company 

will cover the cost of shipping any repaired or replaced product to you in the event the original product was found by the Company 

to be defective.  The Company reserves the right to make changes or substitutions in defective parts or components with material of 

equal quality or value.  
A return authorization number, issued by the Company, is required before returning any product to the Company for warranty claim 

evaluation.  You must provide the product model number, serial number, and invoice number when making a warranty claim within 

the applicable warranty period.  The original serial number and model number labeling must be intact on any product at the time any 

warranty claim is made in order for it to be eligible for a warranty remedy.   You are responsible for the cost of shipping any defective 

product to the Company for inspection.  Damage caused by improper handling while the product is in transit is not covered by this 

limited warranty.  This limited warranty is provided by the Company to the original purchaser and is non-transferable. 

Conditions

The SmartStream

 product must be installed in applications with water quality adhering to the Feed Water Quality Guidelines set forth 

in the Company’s most recently published installation and operation manual or other published product specification sheet.  The prod-

uct must be installed and operated in compliance with the Company’s published installation and operation manual, product specifi-

cation sheet, and local plumbing codes.  This product must be installed in connection with an approved water supply.  This product 

must be operated at water pressures and temperatures that do not exceed the Company’s published specifications.  This product 

is limited to use within atmospheric environments indoors that are within ambient temperature limitations, free from external water 

contact, where relative humidity is below 95% non-condensing, and that are noncorrosive to the product’s materials of construction, 

including its electronic components.  
The use of any unauthorized or inappropriate replacement parts will void this limited warranty.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH 

RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY 

HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE 

IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
The remedy described above in this Limited Warranty shall constitute the sole and exclusive remedy for breach of warranty, and the 

Company shall not be responsible for any incidental, special or consequential damages, including without limitation, lost profits or the 

cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting from labor 

charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any 

other circumstances over which the Company has no control. This warranty shall be invalidated by any abuse, misuse, misapplication, 

improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation 

of incidental or consequential damages. Therefore the above limitations may not apply to you. This Limited Warranty gives you specific 

legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws to determine your 

rights. SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, 

INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN 

DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.

Summary of Contents for SmartStream UV WA002











Reviews: