31
SXT Master Programming Mode - Cont’d
15. Current Day (Display Code CD)
Press the Extra Cycle button. Use this display to set the current day
on systems that have been configured as Day of Week controls. This
setting is identified by “CD” in the upper left corner of the screen. Use
the Up and Down buttons to select from Day 1 through Day 7.
Figure 16
Abbreviation
Description
P0.7
3/4" Paddle Wheel Meter
t0.7
3/4" Turbine Meter
P1.0
1" Paddle Wheel Meter
t1.0
1" Turbine Meter
P1.5
1.5" Paddle Wheel Meter
t1.5
1.5" Turbine Meter
P2.0
2" Paddle Wheel Meter
Gen
Generic or Other non-Fleck Meter
t1.2
1.25" Turbine Meter
17. Meter Pulse Setting (Display Code K)
Press the Extra Cycle button. Use this display to specify the meter
pulse setting for a non-standard flow meter. This option setting is
identified by “K” in the upper left corner of the screen. Use the Up and
Down buttons to enter the meter constant in pulses per unit volume.
Figure 17
Figure 18
K Range: 0.1 to 999.9 pulses per gallon.
18. Relay Setting (Display Code RE)
Press the Extra Cycle button. Use this display to enable the relay
output. This option setting is identified by “RE” in the upper left
corner of the screen. Use the Up and Down buttons to enable
the relay using
either
time based (tb) or flow based (Fb).
Only
one method can be used at a time.
Figure 19
Figure 20
ST Range: 0 to total number of cycles minus 1
Figure 21
ET Range: Start time to total of all cycles
Figure 22
Figure 23
VO Range: 1 to Total Gallon Capacity
Figure 24
TO Range: 1 to 7200 (minutes)
19. End of Master Programming Mode
Press the Extra Cycle button to save all settings and exit Master
Programming Mode.
For time based, set the desired Start Time (ST) and End Time
(ET). Time ranges available are determined by the Regen Cycle
Step Times. For flow based, set the desired Volume Interval (VO)
and Time On (TO).
16. Flow Meter Type (Display Code FM)
Press the Extra Cycle button. Use this display to set the type of
flow meter connected to the control. This option setting is identi-
fied by “FM” in the upper left corner of the screen. Use the Up
and Down buttons to select one of the eight available settings. All
PWS10 systems use a 1" Plastic Turbine Meter.
Summary of Contents for Pure Water PWS10 Series
Page 14: ...14 Wiring Diagram SXT ...
Page 16: ...16 NXT2 Controller Display ...