55
Troubleshooting
b. Ensure that the hot water inlet isolation valve is in the fully Open (ON) position as shown below
c. Check the hot water source set-point temperature and ensure that the hot supply line has no
obstructions or closed valves restricting flow to the IntelliStation.
4. If the “Hot Supply Temp” is ABOVE the “Mixed Outlet Setpoint”, there are no obstructions preventing hot
water from reaching the panel, and there is sufficient flow through the panel, reset the control by press-
ing the icon to access the “Programming” menu. Unlock the control (see “Unlock the System”
of this manual for more detail) and then select the to navigate to the “Toolbox” menu shown
below.
From within the “Toolbox” menu use the icon to highlight “Reset” as shown above then press
. This will access the “Reset” menu shown below.
Closed (OFF)
Open (ON)
No
Load Defaults
No
Flow Units
gpm
Pressure Units
psi
Temperature Units
°F
Energy Units
MBtu
Backlight
100 %
Reset
Back
Up
Down
Toolbox
Enter
?
Summary of Contents for Powers IntelliStation
Page 2: ......
