background image

ATTENTION INSTALLER: After installation, please leave this 

Instruction Sheet for occupant’s information.

IMPORTANT: Inquire with governing authorities for local  

installation requirements.

Limited Warranty:

 Watts Regulator Co. (the “Company”) warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of 

original shipment.  In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.  

THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT.  THE COMPANY MAKES NO OTHER 

WARRANTIES, EXPRESS OR IMPLIED.  THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED 

WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.

The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special 

or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting 

from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no 

control.  This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.  

Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages.  Therefore the above 

limitations may not apply to you.  This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State.  You should consult applicable state laws to 

determine your rights.  

SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF 

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.

IS-MMV-M1  1004 

EDP# 1915906

 

© 2010 Watts 

USA:

  815 Chestnut St., No. Andover, MA 01845-6098; www.watts.com

Canada:

  5435 North Service Rd., Burlington, ONT. L7L 5H7; www.wattscanada.ca

A Watts Water Technologies Company

Summary of Contents for MMV Series

Page 1: ... remove unions and gaskets from valve body prior to soldering 7 After soldering flush piping and install valve using filter washer on hot and cold water inlet and fiber washer on the mixed water outlet 8 Start up Open cold water supply then hot water supply Inspect for leaks 9 Adjust temperature to desired setting see Temperature Adjustment Section Watts recommends a maximum temperature of 110 F 4...

Page 2: ...ure Adjustment 1 Let the water flow for at least two minutes to allow supply temperature to stabilize 2 Calibrate the mixed water outlet temperature by placing a thermometer in the mixed water stream 3 To adjust the setting of the valve loosen locking cap screw with hex wrench see Figure 4 Cap must be lifted 1 4 to adjust temperature To increase the temperature turn coun terclockwise To decrease t...

Page 3: ...and cold side of Tempering valve see Product Guide for piping details D 1 Readjust valve temperature per installation instructions E 1 Clean check valves filters F 1 Reduce water velocity with pressure regulating valves F 2 Check flow required versus rated flow capacity of valve G 1 Open shutoffs or restore hot and cold supply G 2 Clean check valves and filters H 1 Stabilize water pressure with pr...

Page 4: ...ost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly other costs resulting from labor charges delays vandalism negligence fouling caused by foreign material damage from adverse water conditions chemical or any other circumstances over which the Company has no control This warranty shall be invalidated by any abuse misuse misapplic...

Reviews: