Watts IOM-WQ-PROSENSE, Manual

Page: 7 / 30

7
PROGRAMMING MODE continued
In Service Display
Time & Day
Regen Time & Day
Salt Amount
SU MO TU WE TH FR SA DAYS
Capacity
Time & Day
Regen Time & Day
Salt Amount
SU MO TU WE TH FR SA DAYS
Capacity
Hardness
Hardness
Figure 6
The display shows the number of the tank in service (small
digit next to CPH position). The display also alternates
between Capacity Remaining and Flow Rate (faucet icon) for
the tank in service.
NOTE: The Regen icon is only on when in regeneration.
NOTE: The faucet icon is displayed on all the ProSense
controls when there is flow. The ProSense
controller will show the faucet icon when the flow
rate is displayed, even if the flow rate is zero.
The faucet icon will turn off when the capacity
is displayed. In service flow rate display can
be replaced with a clock display using Level II
Programming (Parameter P10).
Programming Overview
The ProSense controller includes multiple program levels that
allow water treatment professionals to customize the system
for many water conditions. Additionally, historical data can be
viewed allowing quick and easy troubleshooting. In most cases
Level I Programming is all that is required to set up the water
conditioning system for proper operation. A brief description of
each program level is listed below.
Level I - Used to program controller for normal applications.
Level II (P-Values) - Allows the installer to customize
programming for non-standard applications.
Level III (C-Values) - Allows the installer to adjust length of
select cycles for non-standard applications.
Level IV History (H-Values) - Allows access to historical
information for troubleshooting the system.
NOTE: If a button is not pushed for thirty seconds, the
controller returns to normal operation mode.
Level I Programming
The ProSense controller can be quickly programmed by
following the sequential procedure in the section "Placing
Water Conditioning System Into Operation". Level I Program
parameters are those that can be accessed by pressing the
UP or DOWN buttons. Step-by-step instructions are shown on
previous page.
• Resin Volume Setting: Set to match the volume (cubic
feet) of resin in the mineral tank.
• Time of Day: Includes PM indicatior. Can be set to display
as a 24-hour clock. See Level II programming.
• Day of Week: Set to actual day of the week.
• Time of Regeneration: Fully adjustable. Default is 2:00 AM.
• Days Override: Range 0.5 to 30 days. Leave at 0 to disable.
• Salt Dosage: Set at pounds of salt per cubic foot of resin
in the conditioner tank.
NOTE: When the controller is set up for a twelve-hour
clock a PM indicator will illuminate when the
displayed time is in the PM hours. There is no AM
indicator.
Programming the Lockout Feature
All Level I parameters can be locked out when the controller
is in Level II Programming. Simply press the REGEN button
during Level II Programming and a lock icon will appear
indicating that the specific setting has been locked out.
When locked out, the setting cannot be adjusted in Level
I Programming. To disable the Lock Out feature, press the
REGEN button when in Level II. The lock icon will not be
displayed.
Resin Volume
The amount of resin can be determined by the diameter of the tank.
Tank Diameter
(inches)
Resin Volume
Cubic Feet
8 0.75
9 1
10 1.5
12 2