5
Startup & Operation:
1.
Slowly turn on the water supply.
2.
Press the red pressure relief button on top of the housing. Hold the button down until
water comes out from underneath the button.
3.
Check for and repair any leaks. If Necessary, tighten the swing bolts with a crescent
wrench or by sliding the shaft of a large screwdriver through the swing bolt eyelet.
4.
Plug in the UV power supply. A green light on the power supply indicates that the lamp
is working properly. A red light and audible alarm indicates that the lamp is either
disconnected or has failed.
The system is now ready to provide filtered water. Periodically check the pressure gauges while
water is flowing through the system. Replace the filter cartridge if the difference between the
inlet and outlet pressures reaches 25 psi.
Maintenance:
Filter Cartridge – Replace every 6 to 12 months depending on feed water
quality or if the difference between the inlet and outlet pressure is greater
than 25 psi while water is flowing.
1.
Unplug the UV power supply and allow the lamp to cool for 30
minutes.
2.
Move the UV power supply so that it will not get wet.
3.
Turn off the water supply to the unit and relieve the pressure by
pressing the red button on top of the unit, or by opening a faucet
down stream.
4.
Remove the UV lamp and quartz sleeve by following the
installation instructions on the previous page of this manual in
reverse order. Place the sleeve and lamp in a safe place to prevent
breakage.
5.
Loosen the eyebolts and remove the lid.
6.
Remove the stainless steel UV vessel from the inside of the filter
cartridge by pulling it up and out (see figure 6). Set it aside for
reuse.
7.
Rotate the filter cartridge counter clockwise and lift it out of the
housing (see figure 7).
8.
Install the new cartridge by lowering it into the housing. Turn the
cartridge clock wise to lock it in place.
9.
Reinstall the stainless steel UV vessel into the center of the
cartridge.
10.
Replace the lid and tighten the eyebolts.
11.
Replace (or reuse, depending on the schedule) the quartz sleeve and
lamp by following the installation instructions on the previous page
of this manual.
UV Lamp – Replace every 12 months
Figure 6
Figure 7
