![background image](http://html1.mh-extra.com/html/watts/hydroguard-hg210/hydroguard-hg210_installation-and-operating-instructions-manual_4525518007.webp)
P a g e
| 7
Mounting Installation
Installation steps:
1.
Mark the desired location for the mounting fixings. See
Product and Position Preparation
2.
Drill the holes and install the anchors (not included).
3.
Align the mounting plate with the anchors and lower into place.
4.
Tighten the fixings to hold the system securely in place.
Plumbing Installation
If installing on a mains water supply, an approved backflow prevention valve must be
installed by a licensed plumber according to local regulations.
1.
Ensure the water supply is off. Connect the inlet and outlet plumbing to the product 1”
(25mm) connections. Unions (not supplied) are recommended at the inlet and outlet for easy
disconnection and maintenance. An isolation valve should be installed upstream and
downstream of the product to allow easy maintenance of the product.
2.
Check that filter cartridges are installed in both housings. The 5 micron sediment filter should
be in the first housing, and the CTO filter should be in the second housing (next to the UV
sterilizer).
3.
Check that 2 sealing O-rings are clean, undamaged and assembled correctly to the filter
housing. If the O-rings are not lubricated, use 100% silicone food grade lubricant to assist
with assembly.
4.
Screw the filter housings into the housing caps. Do not overtighten the housings.
5.
Slowly turn on the water supply and check for leaks at all connections in and around the
product.
6.
If there are no leaks, increase the supply pressure up to the maximum of 500kPa. Check for
leaks again and then open an outlet downstream to flush water through the line for 3-5
minutes. Check again for leaks and then close the downstream outlet.