Page 5
Cut the tube square. It is essential that the outside diame-
ter be free of score marks and that burrs and sharp edges
be removed before inserting into fitting.
Make certain to push the tubing completely into the con-
nector until it comes into contact with the internal tubing
stop. The collet (gripper) has stainless steel teeth which
hold the tube firmly in position while the O-ring provides a
permanent leak proof seal.
Pull on the tube to check that it is secure. It is a good
practice to test the system prior to leaving the site and/or
before use.
To disconnect, ensure the system is depressurized before
removing the tube. Push in collet squarely against the face
of the fitting. With the collet held in this position, the tube
can be removed. The fitting can then be reused.
Cutting
Connecting
Disconnecting
Using Quick-Connect Fittings
System Diagram
3
G
D
E
F
A
B
C
Parts List
Item Part#
Description
A
560080
Adapt-A-Valve
B
142000
Green Tube
C
142001
Blue Tube
D
105311
Sediment Filter
E
105371
LVOC Carbon Filter
F
105321
UF Membrane
G
116113
Brushed Nickel Faucet
