Wattbike ATOM NEXT GENERATION, User Manual

Page: 21 / 30

W
AT
TB
IK
E A
TO
M U
S
ER G
U
ID
E
21
FIRMWARE UPDATES
From time to time we issue firmware updates to keep electronics inside your
Atom up-to-date.
When a firmware update is issued, a firmware request will show on screen when you next
connect your device to your Atom.
TIP: This requires both internet connection and the latest version of the Wattbike Hub to be
installed on your device.
1. Ensure you have the latest app from the iOS App Store or Android Play Store.
2. Go to ‘Just Ride’.
3. Connect to your Atom as if you were starting a ride.
4. Follow the on-screen instructions to update.
TIP: Remember to restart the Atom, turning it off and then on using the switch at the rear. You
must also restart your device.
REPLACING SHIFTERS
If your shifters have permanently malfunctioned and you need to replace them then contact
Wattbike Customer Services to order a replacement shifter.
Shifters are either Left or Right handed; they are not interchangeable. Once you have your
replacement shifter follow the steps below to replace them.
1. Pull back and remove the rubber hood on the shifter
2. Undo the Allen headed bolt securing the shifter to the shifter mount and
remove the shifter
3. Attach the new shifter and screw in the securing bolt
4. Open the Wattbike Hub app that you have used with the bike before:
For iOS devices:
1. Navigate to Settings > Known Wattbikes
2. Select your bike from the list (you must have connected to the bike previously).
3. After a few seconds the app will connect to the bike, the connection circle will go green
and an advanced settings button will appear
4. Tap ‘advanced settings’.
5. Tap the ‘Pair’ button under the shifter you want to change and immediately hold all three
shifter buttons until status reads ‘Connected’.
6. Your new shifter has now paired with your Atom
7. Test the shifter by going into a ‘Just Ride’ session and pressing the buttons
On Android devices:
1. Click the overflow, ‘three dots’ menu item in the top right corner and select
‘Known Wattbikes’.
2. Select your bike from the list (you must have connected to the bike previously).
3. After a few seconds the app will connect to the bike and the circle will go green.
4. Click ‘Advanced Settings’.
5. Click the ‘Pair’ button next to the shifter you want to change and immediately hold all
three shifter buttons until the status reads ‘Connected’.
TIP: Test the shifter by going into a ‘Just Ride’ session and pressing the buttons