44
m-530dun-gb-01
15
Switching the pump on in subsequent power cycles
Subsequent power-up sequences will jump from the start-up screen to the home screen.
l
The pump runs a power-on test to confirm proper functioning of the memory and hardware. If a fault is
found, an error code is displayed.
l
The pump displays the start-up screen with the Watson-Marlow Pumps logo for three seconds followed
by the home screen
l
Start-up defaults are those in place when the pump was switched off last
Check that the pump is set to operate as you require it. The pump is now ready to operate.
All operating parameters may be changed by means of key- presses (see
"Pump operation" on page
17
).
Power interruption
This pump has an auto restart feature which, when active, will restore the pump to the operating state it was
in when power was lost.
Stop/start power cycles
Do not power up/power down the pump more than 20 times in an hour, whether manually or by means of the
auto-restart facility. We recommend remote control where a high frequency of stop/start cycles is required.
Pump will start as soon as power is applied if Auto restart is on and
pump was running when power was disconnected.
