Watson Industries, Inc.
SPS-P230 Rev A 10/17/2017
23
Setting Output Channels
1) Activate Command Mode (See above).
2) To change which channels are output type '&'(this will bring up the main menu again)
3) Type '3’ to set up the channels.
The following message will appear:
4) To proceed type 'Y'
. Stop this process by typing either ‘N’ or ‘Q’.
If ‘Y’ is pressed, each channel will come up one at a time
For example:
5) Type 'Y' to output the channel, type 'N' to remove the channel.
After the last data channel is listed, this message will appear:
6) To accept the new channels, type 'N'. Typing a ‘Y’ will start the command menu sequence over.
Typing a ‘Q’ at any time in the sequence will quit without updating the channels.
Changes made will not change the non-volatile settings. To make these new settings the default
value, send a Quotation Mark (“).
7) Press the space bar after quitting or updating the new channels to restart the data flow.
Adjust Time Constant
1) Activate Command Mode (See above).
2) Type '&'(this will bring up the main menu again).
3) Type '1' to show the current time constants.
The Nominal Time Constant is set at the factory to a value of 64 seconds. This is the main
setting.
Consult the factory for recommendations before adjusting these values.
4) Press the spacebar after changing the time constant to resume data transmission.
TO SET FOR OUTPUT FOR ANY OF THE FOLLOWING DATA ITEMS, PRESS Y
TO AVOID ANY OF THE FOLLOWING DATA ITEMS, PRESS N
TO QUIT AND DISREGARD ANY OTHER DATA, PRESS Q
*** DO YOU WANT TO PROCEED? (Y/N/Q)
DO YOU WANT OUTPUT OF TIME SINCE RESET? N
DO YOU WANT OUTPUT OF TILT ANGLE? Y
DO YOU WANT OUTPUT OF PAN ANGLE?
Y = GOBACK, N = INSTALL DATA & QUIT, Q = QUIT
DO YOU WANT TO TRY TO SET DATA AGAIN?
