2.4
I
Watlow Power Series
Installation, Chapter 2
Removing the Power Series
Controller
1.
To release the Power Series controller from the mounting plate, press in on
the release tab at the top of the mounting plate.
2.
When the release tab is in, push up on the controller from the bottom to
release it from the mounting plate.
Beware of sharp edges on the heat
sink when you push upward. This will take some force!
3.
The F35 model does not use the standard mounting plate. See page 2.2 for
mounting instructions. To remove: reverse the mounting operation.
Maintaining the Power Series
•
Cleaning:
The heatsink fins must be kept clean for proper cooling and the
printed circuit board should be free of conductive residue condensation.
•
Calibration:
Not normally necessary. See pages 6.15-6.16 for data restore
and backup.
•
Retorquing:
See page 3.1 for torque guidelines.
•
Software backup and refresh:
Not necessary; see page A.7, Power Series
Backup.
NOTE: All Power Series controllers have been 100 percent tested before shipment.
Figure 2.4 — The F35 Power Series (right) is cooled with larger fans.
ç
CAUTION:
You may want to use a
large screwdriver to
press in on the release
tab while you are pushing
on the controller to avoid
potential injury to your
hands.
Summary of Contents for PC1X-F20
Page 4: ...ii Watlow Power Series Table of Contents...
Page 72: ......
