Watlow PC1X-F20, User Manual

Page: 69 / 73

Declaration of Conformity
Power Series Power Controller
WATLOW Electric Manufacturing Company ISO 9001
since 1996.
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following products:
Designation: Power Series Power Control
Model Numbers: PC (1, 2, 3, 4, 8 or 9)(0 or 1) – (N or F)(20, 25 or 30)(A, B or C) – (0 or 1)(0 or 1)
any two letters or numbers.
Classification: Power Control, Installation Category III, Pollution degree 3, IP00
Unit Supply: 100-240 V~ (85 – 264)(ac), 50 or 60 Hz, 60 VA
Load Supply: 24 to 600 V~ (ac), 50 or 60 Hz, 65 to 250 A depending on model.
Meets the essential requirements of the following European Union Directives by using the relevant
standards show below to indicate compliance.
2004/108/EC Electromagnetic Compatibility Directive
EN 61326-1: 2013 Electrical equipment for measurement, control and laboratory use –
EMC requirements (Industrial Immunity, Class A
1,2, 5
Emissions)
Not for use in a Class B environment without additional filtering.
EN 61000-4-2:2009 Electrostatic Discharge Immunity
EN 61000-4-3:2010 Radiated Field Immunity 10V/m 80 MHz- 1GHz, 3V/m 1.4GHz-2.7GHz
EN 61000-4-4:2012 Electrical Fast-Transient / Burst Immunity
EN 61000-4-5:2006 Surge Immunity
EN 61000-4-6:2014 Conducted Immunity
EN 61000-4-11:2004 Voltage Dips, Short Interruptions and Voltage Variations
EN 61000-3-2:2009 Harmonic Current Emissions
4
EN 61000-3-3:2013 Voltage Fluctuations and Flicker (Unit Supply)
EN 61000-3-11:2000 Voltage Fluctuations and Flicker
3
(Load Supply)
NOTES
1
Use of an external filter is required to comply with conducted emissions limits. See note 5 below.
2
A Line Impedance Stabilization Network (LISN) was used for conducted emissions measurements.
3
To comply with flicker requirements will require a reduced source impedance.
4
Phase angle control mode will not pass harmonics, burst fire control mode meets requirements.
2006/95/EC Low-Voltage Directive
EN 50178:1997 Electronic equipment for use in power installations.
Per 2012/19/EU W.E.E.E Directive Please Recycle Properly.
These devices contain lead solder and are not RoHS compliant.
They are Industrial Control Devices and fall outside the scope of 2011/65/EU Directive.
5
Required External EMI Filters for Power Series with More Than 6 Amp Loads
An external ElectroMagnetic Interference (EMI) filter must be used in conjunction with the Power Series for loads
in excess of six amperes (6A) at 150 to 250 KHz. Watlow has verified that the following tank filters will suppress EMI
created by SCR power controllers to comply with the conducted emissions limits.
Description Crydom Filter Watlow Filter
Single-Phase 230 V~ (ac) 1F25 14-0019
Three-Phase 440 V~ (ac) 3F20 14-0020
A . 1 4
I
A p p e n d i x Wa t l o w P o w e r S e r i e s