WATEX Ltd., Latvia, Riga, Ganibu dambis 27 k-5,
, Tel. +371 67381989, www.watex.eu
10
Reagent tank connection
The kit contains a reagent tank as well as a 3/8 "connecting pipe. The flexible plastic tube is placed in the reagent container
under the lid. The reagent tank should be placed next to the filter tank. Can be placed on any side of the filter tank.
The reagent tank has a plug that is placed in the plastic container of the reagent tank. Remove the float and remove the transport
rubber put on the bottom of the float. Threads do not have to use packaging materials.
Remember!
The regeneration tank will need to be filled with a reagent on a regular basis, so it is advisable to place it where it is easily
reachable.
The control panel is shown in the drawing, highlighting the connection point of the reagent supply line. The pipeline connection
is carried out as follows:
1.Unlock the control unit reagent by removing the
clamp and removing the reagent attachment elbow.
2. Pull the pipe through the nut
3. Place the cylindrical insert on the end of the tube,
then make two consecutive rings.
4. Insert the end of the tube into the bend hole to the
end and tighten with the nut. Manual engagement.
5. Place the reagent joint in the opening and place the
clamp.
Note: The reagent connection elbow has a sealing
ring, it can be rotated in the desired direction.
Turning angle is 270
o
.
6. The end of the second tube is drawn through the
hole in the side of the reagent tank and added in the
same manner as in paragraphs 2, 3 and 4.
When the equipment is connected to the water
supply, drainage and reagent tanks, in the reagent
container, fill salt tablets (NaCl) in Brine tank.