www.watersnake.com.au
21
• Ensure that your Watersnake motor is securely attached to your boat
(refer to page 7 of manual)
• Fully charged 2 x12v deep cycle or 2 x 12v LiFePO4 batteries or
1 x 24v LiFePO4 battery
(your Watersnake motor is not designed to be used with a car / truck /
motorcycle or marine cranking batteries)
• Check battery cables for any signs of damage or exposed wiring
• Check terminals for any signs of corrosion or debris
• Check Anderson plugs are clean and corrosive free
• Ensure Anderson plugs are connected together properly
USING THE MOTOR
PRE-USE CHECKLIST – CHECK BEFORE EACH USE
ATTACHING THE PROPELLER
IMPORTANT!
BEFORE DOING ANYTHING WITH THE PROPELLER, ENSURE
THE CABLES TO THE BATTERIES ARE DISCONNECTED.
1:
Place shear pin in shaft as shown.
2:
Align the propeller against the shear pin on the shaft
(there is a groove on the back of the propeller which the shear pin
needs to slot into) and then tighten the propeller nut securely using
the propeller wrench.
Do not overtighten; check regularly.
PROPELLER ASSEMBLY
1
Shear pin
2
Propeller
Propeller
nut
Propeller shaft
Propeller wrench
PLEASE NOTE:
I
t is suggested that you have
a spare propeller and
propeller accessory kit in
your boat at all times.