www.watersnake.com.au
11
FIERCE
SYNCING THE REMOTE CONTROL HAND UNIT TO YOUR
WATERSNAKE MOTOR
NOTE – before proceeding remove the propeller (if fi tted) from your
Watersnake motor
• Remove the top cover of the motor head cover (4 x phillips head screws)
• Ensure that your motor is in the deployed (vertical) position and that it is
connected to your 12v deep cycle battery
• Press and hold down the RC chip button (light may fl ash or stay lit – either is
OK) – refer to diagram on page 20
• At the same time, press and hold either the left (refer to new diagram
function number) or the right (refer to the new diagram function number)
button on the remote control hand unit
• Slowly count to 10 whilst holding both buttons
• Release both buttons
• Test that the sync process has been completed by pressing one of the
function buttons on the remote control hand unit
• If the remote control hand unit fails to sync with the motor repeat above
steps until the sync process is successful
NOTE – It may take several attempts for the remote control hand unit to
sync successfully with your Watersnake motor. This is not necessarily an
indication of a fault although if repeated attempts fail it may indicate that
the battery in your remote control hand unit needs replacing
Motor head cover
Remote Control hand unit
Summary of Contents for Fierce SWRF 54/48
Page 1: ...FIERCE BOW MOUNT ELECTRIC MOTOR OWNERS MANUAL...
Page 20: ...Watersnake 20...
Page 21: ...www watersnake com au 21...
