©Copyright Watershed Innovations. All rights reserved.
HydraPump Documentation Rev 2.0
INSTALLATION
The following steps should be taken before operating the pump
1.
Connect a flexible hose or stationary pipe to the outlet port of the pump.
PTFE tape, or plumber’s tape is recommended to be used on the connections
for a better seal.
2.
When the pump is in its location of operation, insure that it is resting flat on
its bottom surface and will not experience suddenly movement during
operation.
a.
The pump may rest on some silt or debris since it will only draw down
to 1” water height. However, it is recommended that the resting
surface be as clean as possible.
3.
Make sure that the plug end of the power cord is safely out of the water and
will not come in contact with the water during operation.
4.
Set the float switch position but first note that the pump will operate when
the float is up.
a.
If a specific height is required for operation, the float switch can be
tethered using the notch on the handle.
b.
After the float has been set, always test to make sure that the desired
operation is being achieved.
OPERATING
Once the pump is installed it only needs to be plugged in to operate. The pump
should not be left to operate if it is not pumping water since this may damage it.
For situations where the float switch is being used, depending on the tether location,
there will need to be enough water to trigger the float to activate the pump. While
the pump does have safety features it is always important to verify functionality of
the pump. Make sure when using the float, that the float turns the pump off and on
as expected. Please contact Watershed Innovations if there are any questions or
concerns about the installation or operation of the pump.
WARNING
: This pump is water cooled and recommended to operate at water
temperatures below 82°F but not below 32°F or in an icy environment.
CAUTION
: Water and electricity do not mix. Make sure to continuously check that
the power connections and cables to make sure they are not in contact with water.
Consult a professional if you have any questions or concern about the electrical
circuit or pump operations.
PUMP INSTALLATION AND OPERATING INSTRUCTIONS
