24 | 41
Assembling the Impeller Shaft
Use the illustrations and instructions to assemble
the impeller shaft.
1 Apply grease to the driven gear, then press it
into the bearing.
2 Insert the key into the keyway. Apply grease
to the shaft, then press the driven gear onto
the shaft.
3 Install the washer and locknut onto the end of
the shaft, then tighten the locknut.
4 Apply grease to the shaft, then install the
bearing spacer onto the shaft.
5 Apply grease to the bearing, then press the
bearing housing onto the shaft.
6 Install the flinger ring onto the shaft with the
rounded edge toward the bearing housing.
Note:
The flinger ring should sit 1/16 inch
(1.5875 mm) from the edge of the
inner shoulder.
1
2
3
4
5
6
100 ft-lb
136 N∙m
Summary of Contents for CP-4
