WL2FLT
Manual Page 65
–
Revision 10-26-2021
RESETTING THE HOT TANK OVERLOAD OR HIGH LIMIT SAFETY
1.
Red Compressor/Heater Switch must be in the
O=OFF
position
2.
Unplug the Power Cord from rear of
WL2FLT
Water Treatment System.
3.
Remove the Side Panel by removing the Front Hatch and Side Panels.
4.
Locate the Hot Tank
5.
Press the Reset Button
6.
Replace the Lower Front Panel.
7.
Plug in the Power Cord.
8.
Turn on the Red Compressor / Heater Switch
I=ON
position
The Hot and Cold Tanks must be filled with water BEFORE turning on
the Red Heater and Compressor Switch.
9.
Verify the cooler is fully operational before
installing it at the customers’ site.
