page 1
This unit has a control valve which enables the setting of not only the length of each regeneration cycle but also the
order in which cycles (steps of regeneration) occur. The following pages instruct how to set the treatment unit’s
sequence of cycles, cycle times, salt dose, exchange capacity, and gallon capacity/regeneration time. A salt
warning option may also be included.
THE DEALER...
1. Read this page, GENERAL INSTRUCTIONS, INSTALLER SETTINGS, NORMAL OPERATING
DISPLAYS, and LOW SALT WARNING.
2. Complete the CYCLE SEQUENCE SETTINGS.
3. Complete the SOFTENER SYSTEM SETUP.
a. Cycle Times
b. Choose Softener or Filter
c. Set Salt Dose
d. Set Capacity
e. Set How Gallon Capacity Will be Calculated
f. Set Regeneration Time Option
g. Select or Turn Off Low Salt Warning
THE INSTALLER...
1. Read Bypass Valve page.
2. Read GENERAL INSTRUCTIONS, NORMAL OPERATING DISPLAYS, and RESETTING LOW SALT
WARNING (if applicable).
3. Be sure CYCLE SEQUENCE SETTINGS and SOFTENER SYSTEM SETUP are done before leaving for
installation.
4. Follow INSTALLATION INSTRUCTIONS, INSTALLER SETTINGS, TIME OF DAY, and RESETTING
SALT AMOUNT (if applicable).
5. Follow START UP INSTRUCTIONS.
PREINSTALLATION INSTRUCTIONS
TABLE OF CONTENTS
Preinstallation Instructions for Dealer.......................inside front cover
Specifications.................................................................................1
Cycle Sequence Settings................................................................2
Softener System Setup (programming)...........................................3-5
Bypass Valve Description & Diagrams..............................................6
Installation...................................................................................7-8
Installer Settings....
Hardness, Override, Regen Time & Time of Day......................9
Normal Operating & Error Displays, Power Loss..................10
Low Salt Warning & Resetting It.........................................11
Start Up Instructions......................................................................12
Replacement Parts & Valve Repair
Front Cover, Drive Assembly and Piston..............................13
Injector Assembly & Refill Port Assembly............................14
Drain Line 3/4" Assembly & Flow Controls..........................15
Drain Line 1" Assembly & Flow Controls.............................16
Water Meter & Bypass Valve..............................................17
Installation Fitting Assemblies & Service Wrench.................18
Control Valve Servicing..............................................................19-23
Troubleshooting Procedures.......................................................24-25
Summary of Contents for FUSION2 F Series
Page 9: ......
