INSTALLATION INSTRUCTIONS / USER MANUAL
12
Battery change
The enclosed sensor batteries has an expected life of approx. 5 years.
We recommend a battery change after max 5 years. Sensors with weak batteries may, if placed far away,
not connect with the central unit.
In case of low batteries, the central unit will warn with an audio signal only. The unit will remain in its initial
state without closing the solenoid valve. The number of audio signals from the central unit will correspond
with the sensors registration number when installed. The alarm is repeated every 25 seconds.
Reset the alarm with a brief push of RESET. Take note of the number of signals/which sensor has triggered
before you reset the alarm.
1 Remove the sensor from the wall bracket by pulling it approx. 5mm
upwards and then pulling it straight out. Remove the top lid by using
the small slots on the side.
2 Remove the batteries and insert new of the same type (AAA). Push
the switch (marked with red on pic 2) and check that the LED on the
right side starts flashing. Put the lid back on.
3
Test the sensor:
(see also 4 below)
Place a moist cloth or finger on one of the sensor points, the alarm
should immediately be released. After cancelling the alarm, carefully
dry the moisted sensor point.
4 Put the sensor back where it was. This test can advantageously be
run also after having mounted the sensor in place, by moistening
the sensor cable.
User manual
