8
Installation of Spigot
See separate installation instructions for spigot
Installation of Membrane
Important:
Keep the membrane and your hands
clean in order to avoid bacterial contamination of the
membrane.
1. Disconnect the hose on the end of the
membrane housing end cap.
2. Unscrew the end-cap.
3. Hold the membrane upside down, cut the plastic
bag at the bottom, and drain off any liquid.
4. The bottom tip of the membrane must seat firmly
in the protruding female socket inside the
membrane housing.
5. Without touching the membrane, slide it into the membrane housing and discard the plastic bag.
With your thumb or the palm of your hand, push the membrane all the way into the housing.
Important:
Do not use force, and ensure that the membrane is not protruding from the housing.
6. Replace the membrane housing end cap and hand tighten.
7. Push the tubing back into the quick connect fitting. Ensure the tubing is all the way in.
Connecting Components
a. Connect the 1/4" green tube from the (90° elbow) 5 micron pre-filter fitting to the fitting on the cold
water supply line.
b. Connect the 3/8" blue tube from the (90° elbow) granular activated carbon post-filter fitting to the
quick connect fitting on the threaded pipe on the spigot.
c. Connect the 3/8" blue tube from the (male tee) granular activated carbon post-filter fitting to the fitting
on the storage tank.
d.
Standard Faucet
- Connect the 1/4" black tube to the drain fitting.
Figure 8 - Installing membrane without touching
Summary of Contents for E75TFC-3
Page 2: ......
Page 21: ...17 Reverse Osmosis Drinking Water System Flow Diagram all models...
Page 23: ...19...
