I
pg 05
Hydroxzone Ozone Generator
NOTE:
For 50mm pipe, do not use 40 mm adapters and gasket and turn bushings so small
end points toward Injector (for Entrance) or PVC Pipe (for Exit).
Figure 2.2
Saddle Clamp Assembly
at Bypass Entrance
Figure 2.3
Saddle Clamp Assembly
at Bypass Exit
Venturi Injector
Screw (2)
Saddle Clamp Top
Bushina
Top Adapter
Gasket
22mm (7/8”) Dia. Hole
Bottom Adapter
Saddle Clamp Bottom
1/4-20 Nut (2)
PVC Pipe
Screw (2)
Saddle Clamp Top
Bushing
Top Adapter
Gasket
22mm (7/8”) Dia. Hole
Bottom Adapter
Saddle Clamp Bottom
1/4-20 Nut (2)
NOTE:
If your filtration system uses a Diatemateous Earth (DE) or cartridge filter, install a
20mm (¾”) Ball Valve (not included) in the 20mm (¾”) Hose on the output side of the Venturi
Injector as shown in Figure 1.1. This allows the bypass to be closed when back flushing or
adding DE. It may be necessary to install a Ball Valve (not included) in the main line between
the Entrance and Exit of the bypass. The Ball Valve will need to be adjusted to ensure
adequate flow through the bypass.
