Waterco Aquamaster
I pg 27
If Pool and Spa is selected
If a Spa Spill over is featured in the installation ensure either option a. or b. is selected as detailed
below:
a. If the “Spill over – Spa Return” icon is displayed the automated valves should be configured to
take water from the pool and return pool water via the spa.
b. If the “Spillover – Pool / Spa Return” icon is displayed the automated valves should be configured
to take water from the pool and spa and return water in the same proportions back to the pool
and spa.
If heating is to start when SPA MODE is selected ensure the check box is ticked and Spa Mode
Timeout is programmed and press Enter to the next screen.
Pool Heating
> Select your heating requirements
> No Heating
> Heat Pump
> Gas Heater
> Solar
Press “Enter” to proceed to configure your selection.
If “Gas Heater” is selected the “Gas Heater Settings” Menu will appear.
If “Heat Pump” is selected the “Heat Pump Settings” Menu will appear.
Is the heater independent of or integrated to the filtration system?
Select either the “Independent” or “Integrated” icon relevant to your pool hydraulic configuration.
Press the “Temp Check Period” icon to alter the period between the system checking the pool
temperature via operation of the filter pump. The period may be set to check between 1 and four
hours in half hour increments.
Press the “Heater Timer” icon to set the gas heater operation times.
If “Integrated” is selected a “Heating Demand Option” icon will appear. Effectively, if this function
is activated it will override any filtration timer setting and will keep the gas heater heating the pool
water until the set temperature is reached. The Heating Demand Option may be controlled by the
Demand Mode Timer which is accessed via the “Demand Mode Timer” icon.
Press “Enter” to proceed to configure your selection.
If “Solar Heating” was selected the “Solar Heating Settings” Menu will appear.
Is the Solar independent of or integrated to the filtration system?
Select either the “Independent” or “Integrated” icon relevant to your solar hydraulic configuration.