background image

Dealer Name: 

Dealer Phone Number                                                     Installation Date:

Model Number:                                           Serial Number

CUSTOMER CHECKLIST

After installation, installer should make sure of the following:

F

 Customer has a Care and Use Guide and warranty card

F

 Customer knows how to restart system if power goes out

F

 Customer knows how to put the system in bypass in case of an emergency

F

 Customer knows what kinds of regenerant to use in brine tank

F

 Customer knows where to purchase regenerant salt or potassium chloride

F

 Customer knows how often to check regenerant salt/potassium level

F

 Customer knows how much salt or potassium chloride to put in brine tank

F

 Customer knows how to contact dealer in case of service needs

F

 Customer is aware the warranty card must be fi lled out and mailed in or 

submitted online to activate warranty coverage

Dear REIONATOR Customer:

Congratulations on your purchase of a Water Tech REIONATOR water conditioner 
equipped with the Triton control valve. This is a premium quality system that is only 
available through authorized Water Tech Dealers.
With minimal care, your system is designed to serve you for many years. I hope you 
enjoy your new REIONATOR.

Sincerely,

Mark Russell
President

DEALER CONTACT AND PRODUCT INFORMATION

14

Specifi cations

The REIONATOR

 is a DIR (demand initiated regeneration) softener which complies 

with specifi c performance specifi cations intended to minimize the use of regenerant 
brine in its operation.
This water softener conforms to NSF/ANSI Standard 42 for reduction of aesthetic chlo-
rine and NSF/ANSI Standard 44 for softening effi ciency as verifi ed and substantiated 
by test data. While testing was performed under laboratory conditions, due to varying 
water conditions actual performance may vary.
The REIONATOR has been tested according to NSF/ANSI Standard 42 for the reduction 
of the substances listed in the table below. The concentration of the substance in the 
water entering the system was reduced to a concentration less than or equal to the 
permissible limit for water leaving the system as specifi ed by NSF/ANSI Standard 42.
The REIONATOR is not intended for use in treating water that is microbiologically 
unsafe or of unknown quality without adequate disinfection before and/or after 
the system.
Usage of the REIONATOR in a manner other than prescribed in the manufacturer’s 
warranty will void the REIONATOR limited lifetime warranty.
As with any appliance, proper operation and maintenance is required to ensure trou-
ble-free operation. Please consult your local authorized Water Tech dealer for service.

MODEL

AESTHETIC CHLORINE
REDUCTION (GALLONS)

RC32-TM

810

RC40-TM 1000
RC48-TM

1180

RC64-TM

1580

RC80-TM

1960

Summary of Contents for REIONATOR Classic Series









Reviews: