Plumbing Connection
raw
water in
raw water to
outside faucets
conditioned
water in
hot
cold
hot water heater
Triton Bypass Valve
Typical Plumbing Installation
STOP
Check local
codes for
minimum
run between
Reionator unit
and water heater
Important: Brass or plastic
yoke assembly (not shown) is
required to connect piping to
the bypass valve and is available
in either NPT or solvent.
5
Set Time of Day / Power Loss
The user can also set the time of day. Time of day should only need to be set after
extended power outages or when daylight saving time begins or ends. If a power
outage lasting longer than two hours occurs, the time of day will fl ash on and off
which indicates the time of day should be reset. All other inputs will be retained by
the system and will not need to be reprogrammed.
STEP 1
Press SET CLOCK.
STEP 2
Current Time (hour): Set the hour of the day using
the
or
buttons. AM/PM toggles after 12. Press
NEXT to go to step 3.
STEP 3
Current Time (minutes): Set the minutes of the day
using the
or
buttons. Press NEXT to exit Set
Clock. Press REGEN to return to previous step.
ERROR MESSAGE
If the word “ERROR” and a number are alternately
fl ashing on the display, contact an authorized Water
Tech dealer for service help. This indicates that the
valve was not able to function properly. This is a
rarely encountered malfunction.
10
