8.913-970.0 - L • WATERMAZE CLP 5024/7034
OPERA
T
OR’S MANU
AL
W
A
TER TREA
TMENT
SYSTEM
6
INTRODUCTION & SAFETY INFORMATION
or explosive fl uids such as gasoline, fuel oil, kero-
sene, etc. Do not use in explosive atmospheres.
Pumps should only be used with liquids compatible
with pump component materials. Failure to follow
this warning can result in personal injury and/or
property damage.
AVERTISSEMENT: Les pompes devraient être utili-
sées uniquement avec des liquides compatibles
avec les matériaux des composants des pompes. Le
non-respect des précautions peut mener à des lé-
sions corporelles et/ou des dommages à la propriété.
3.
WARNING: Risk of electric shock.
AVERTISSEMENT: Risque de choc électrique
All wiring should be performed by a qualified
electrician.
4. Never make adjustments on the machine while it
is in operation, except for those prescribed in this
manual.
5. The main power must be brought from the circuit
breaker and wired into the electrical box on the CLP.
This line must be run through conduit to protect it
from damage. A power disconnect should be located
next to the machine for maintenance purposes.
6. Before servicing the machine, refer to all the MSDS’s
on the material identifi ed in the wastestream. You
must comply with all warnings and wear all protec-
tive clothing as stated on the MSDS’s.
7. Protect all electrical cords from sharp objects, hot
surfaces, oil, sunlight, and chemicals. Avoid kinking
the cords. Replace or repair damaged or worn cords
immediately. All wiring should be run through conduit.
8. Inlet water temperature must not exceed 85°F.
9. Disconnect the power before servicing this machine.
If the power disconnect is out of sight, lock it in
the open position and tag it to prevent unexpected
application of power.
10. The best insurance against an accident is precaution
and knowledge of the equipment.
11.
WATER MAZE
is not liable for modifi cations or use
of components not purchased from
WATER MAZE
.
12. Personal Safety:
a. Wear safety glasses and other applicable
protective clothing at all times when working
on the CLP.
Refer to item #6 under Important Safety
Information.
b. Keep your work area clean, uncluttered and
properly lighted. Replace all unused tools and
equipment.
WARNING
RISK OF EXPLOSION:
DO NOT SPRAY
FLAMMABLE LIQUIDS.
WARNING
KEEP WATER SPRAY
AWAY FROM
ELECTRICAL WIRING.
IMPORTANT
SAFETY
INFORMATION
CAUTION: To reduce the risk of
injury, read operating instructions
carefully before using.
ATTENTION: To reduce the risk of
injury, read operating instructions carefully before
using.
1. Read the owner’s manual thor-
oughly. Failure to follow the instruc-
tions will cause a malfunction of the
machine and result in death, serious
injury and/or property damage.
WARNING: Ground system before
connecting to the power supply.
AVERTISSEMENT: Mettre le sys-
tème à la masse avant de le rac-
corder à la source d'alimentation.
WARNING: Wire the system for
correct voltage. See “Electrical”
section of this manual and motor
nameplate.
WARNING: Meet the National
Electrical Code and local codes
for all wiring.
AVERTISSEMENT: Respecter le
Code national de l'électricité et les codes locaux
pour tous les câblages.
WARNING: Follow the wiring instructions in this
manual when connecting the system to the power
lines.
AVERTISSEMENT: Suivre les instructions de câblage
dans le présent manuel au moment de
raccorder le système aux lignes de transport
d'électricité.
WARNING: All wiring must be performed by a quali-
fi ed electrician.
AVERTISSEMENT: Tout le câblage doit être effectué
par un électricien qualifi é.
2. Know the system application, limitations, and poten-
tial hazards.
W A R N I N G : D o n o t u s e t o p u m p
c o n c e n t r a t i o n s o f f l a m m a b l e
WARNING
READ OPERATOR’S
MANUAL THOROUGHLY
PRIOR TO USE.
CAUTION
