Water Depot Blaster Soft, Owner'S Manual, Page: 14 / 32

14
To Clean the CD Cell:
1.) Remove the CD Cell outlet tubing at the locations shown above.
2.) Disconnect the CD Cell H.V. wire from the frequency driver.
3.) Disconnect the CD Cell from its grounding clips and remove from generator.
4.) Run warm water through the inlet tubing until the water from the outlet tubing runs
clear and free or particulates.
5.) Use compressed air to completely dry the interior and exterior of the CD Cell prior to re-
installing.
6.) Re-install the CD Cell in reverse order of steps 1-4
CD Cell Inlet Port
CD Cell Outlet Port
CD Cell H.V. Wire Connection